page1
DRAWN BY
C. HUYNH
2/2014
TITLE
SIZE
REV.
DWG NO.
SHEET
LCD Extension
Copyright © 2014 Aleph Objects, Inc.
Permission is granted to copy, distribute and/or modify this document
under the terms of the Creative Commons Attribution 4.0 International
Public License (CC BY-SA 4.0).
TAZ 4.0
25 Pin Plug (male)
STEP 3: Insert cables in by hand as below
Pay attention to Pin1 loc &
orientation of connector
Use first
10 pins
Use last
10 pins
Skip middle 5
STEP 4: Press Cable onto pins
Finished 25P-Conn. Side
STEP 5: At other end of the harness,
Insert cables in by hand as below
STEP 6: Press cables onto Conn./Pins
As in STEP 4
Finished 10P-Conn. Side
STEP 8: Install 25-Pin
Connector Backshell
Pay attention to where
the unshielded
& the shielded part
rest on the housing
Build
Process
Instruction
“Triangle”
this side!
STEP 1: Cut 2 pieces of 10Cond Shielded Cables, L=335mm
STEP 2: Strip shield jacket off 40mm at 1 end
and 15mm at the other end.
STEP 7: Loop cable back over as shown,
& snap in the strain relief bracket
15
40mm
335 mm